Home > Water Heater > Why Is My Electric Hot Water Tank Not Working

Why Is My Electric Hot Water Tank Not Working

Contents

Make sure wires are firmly under screw plate. What happens is that the poor connection doesn't conduct electricity very well and gets warm due to the current flowing through it to the heater. Are there scorch marks or signs of water? Actions: How to test elements. navigate here

Show more Language: English Content location: United States Restricted Mode: Off History Help Loading... Bad faucet cartridge or crossover problem: Read about Crossover Other causes: red reset button tripped, upper thermostat bad, upper element burned out, loose or shorted wire: read steps below. ✔ Test If your heater is approaching old age, replacement may be smarter than repair. If the hardware store doesn't have them, try a plumbing wholesaler. -- Larry (1995-2000) Burned-Out Element Q: I have a 40-gallon electric water heater that is 18 years old.

My Water Heater Is Not Heating Water

Repeat on the other screw. I have replaced the upper element and the control board and the still no hot water and the reset light is dimm.- Lee 1/21/2013 Reply: Trevor, quite so, if everything on You may need to drain water pressure from the system or even drain piping in order to make repairs, especially if soldering is needed.

Stand on dry boards. Today, most homes have backflow prevention valves which stop the water in your home from reentering the water supply. Action: Turn off power and test elements Shorted wire or burned part. Electric Water Heater Thermostat Turn electricity back on so you can test parts. 3.

The element will still be cracked. Electric Water Heater Reset Button The heater is shot. Identify the power supply wires. see it here Above are photographs of a replacement electric water heater upper thermostat (including its reset button) and the smaller lower water heater thermostat.

Wear goggles. 2) Water heater could be cause. How To Test Water Heater Element You'll need a multimeter for this. Action: Check temperature setting on thermostat TP valve leaking How to check & replace TP valve ✔ Suddenly LESS hot water: Tank has some hot water a) If tank has Sign in to add this video to a playlist.

Electric Water Heater Reset Button

If they’re covered by metal conduit, the tester won’t read voltage. Get More Info Loose wires cause burning and melting and should be visible on inspection, and/or cause burned smell. My Water Heater Is Not Heating Water That's done by disconnecting wires and checking at each screw terminal and at ground. How To Tell If Electric Water Heater Is Working Do you have any suggestions on what else I should try?

Reader follow-up: Also, there was evidence that a short had occurred in lower element region as there were burn marks on or near cover or where there was an electrical malfunction, http://nadrp.com/water-heater/why-is-my-electric-hot-water-heater-not-working.html Thermostat must sit flat against tank. Water hammer Water hammer arrestors at Amazon Larger image Water hammer arrestors at Amazon ✔Air bubbles come out of faucet Air sputters out of faucet 1) Water well... Test L3 to T2 and then L3 to T4. Gas Water Heater Not Working

Sign in to add this to Watch Later Add to Loading playlists... Action: Turn off main breaker, Tighten both wires on circuit breaker. 2) Loose breaker can trip breaker. If reset will not stay pushed in, then replace thermostat Use nose and eyes to inspect for signs of high heat and burning. http://nadrp.com/water-heater/water-tank-thermostat-not-working.html Repeat the test on the second terminal.

If the tank is hot only from the upper element up, then the upper thermostat is suspect. -- Larry (1995-2000) Q: After installing a new electric water heater and filling with Electric Hot Water Heater Not Working After Power Outage Factory-installed heat traps at top of tank are clogged. But I'd prove it with a meter before I started changing parts wholesale. -- David Q3 : My tank has two 4500W elements and measured voltage is 234 so you could

If the elements are not shorted and there are no other electrical problems you can find, I'd replace the thermostat unit.

Try unscrewing the bad element by turning it counterclockwise (Photo 4). That means the lower thermostat isn't working and needs replacement. Leaking fittings can often be tightened or repaired. Not Enough Hot Water From Electric Water Heater If circuit breaker is burned or broken, water heater receives 120V, so heater appears to have electricity but is not working.

Have your spouse knock you loose from wires using a 2x4, and then treat possible stopped heart and 3rd degree burns. a 5% discount on any number of copies of the Technical Reference Guide purchased as a single order. The reason for that is that 220-volt can be dangerous. weblink Action: Fix leaks.

This is in addition to the new gasket. The Home Reference Book - the Encyclopedia of Homes, Carson Dunlop & Associates, Toronto, Ontario, 25th Ed., 2012, is a bound volume of more than 450 illustrated pages that assist home